1931 Ford Model A

1931 Ford Model A Hot Rod Coupe. All steel body, powered by a camaro 327 with 2.02 heads, Borg Warner 5 speed trans with hydraulic clutch, and a 3.73 10 bolt rear end.  The frame is a Model A chassis that has been modified and boxed. It has a custom fabricated k member. Rear suspension is a braced hair pin set up with qa1 coilovers. Front is a superbell axle with split wishbones, reverse corvair steering box, and disc brakes. It has a reproduction deuce grille, and a stock model a hood. All the glass is new tempered green tint. The body has had a few mods including a custom made firewall, trans tunnel, and floor pans.  The interior is a brown and green plaid with black pleated door panels. All but a couple pieces of the wood structure have been replaced. Some original pieces were in good enough shape to just refinish. This car has been driven quite a bit since it's build in June of 2015. I've driven it about 15,000 miles in that time. This car is extremely reliable with the warmed over 327. It has a Mallory dual point dizzy, edelbrock intake and Holley carb, a mechanical fuel pump, and 14 gallon fuel cell behind the rear axle. It gets about 20mpg. It has an aluminum 3 row radiator and mechanical fan with a shroud. It does not overheat, at all. I've done many hot August nights cruises and a ton of sitting in traffic on the freeway during commute hours and never had an issue.  The hand-lettering on the door is of a fictional shop and can be removed before purchase if desired.Trim: Hot RodDoors: 2