NO LONGER AVAILABLE Listing ended Oct 5, 2026

1962 Chevrolet Corvair

$6,395

Vehicle Details

Make

Chevrolet

Model

Corvair

Year

1962

Mileage

53,000 miles

VIN

AMS32250

Body Type

Coupe

Transmission

Manual

Fuel Type

Gasoline

Description

1962 Corvair 900 Manza Air cooled flat 6 (non turbo) Four on the floor Mechanically car is good Runs, drives, stops. 53,xxx miles. This car wont last long

Classic Chevrolet Corvair Buyer's Guide

Full guide

Mike Sullivan

Muscle Cars

1960–1969

~3 min read

Updated Apr 2026

Expert buyer's guide to the Chevrolet Corvair 1960–1969. Cooling tin inspection, engine seal diagnosis, Corsa turbo identification, suspension generations, and market pricing.

This guide covers

✓ 10-point inspection checklist

✓ Common issues & what to avoid

✓ In-person inspection guide

✓ Market pricing by year & condition

✓ 5 FAQs answered

✓ History & fun facts

Read the Full Corvair Buyer's Guide

Chevrolet Corvair Market Overview

Based on 32 Chevrolet Corvair listings currently on ClassicCarsArena.com

Listed Now

$18,613

Avg. Asking Price

1960–1976

Year Range

Price Position on Our Site - Below Average

This car: $6,395

Low: $5,995 High: $45,895

Transmission Distribution

Automatic 28%

Manual 50% ◄

Condition Distribution

Excellent 16%

Good 22%

Fair 6%

Data from ClassicCarsArena.com listings Browse all 32 listings →

🔑

Selling a classic? Here's how

Fees, audience and photo limits compared: compare the places to sell classic cars .

List Yours →

Classic Chevrolet Corvair Buyer's Guide

The Chevrolet Corvair was the most technically adventurous American car of the 1960s and the most politically controversial. Air-cooled, rear-engined, and available with a turbocharged engine two full decades before turbos became mainstream, the Corvair offered genuine European sports car character at Chevrolet prices. Ralph Nader painted it as dangerous; independent government testing largely exonerated the design. Today the Corvair is a legitimate collector car with a devoted community, excellent club support through CORSA, and one of the most engaging driving experiences in the classic American market, but its unique air-cooled engineering demands a buyer who knows what to inspect.

What to Check Before Buying

✓

Cooling Tin Audit , Open rear decklid and verify every piece of cooling shrouding is present, correctly installed, and undamaged. Missing tin = overheating risk.

✓

Push-Rod Tube Inspection , Check all 12 push-rod tubes for oil seepage. Light weeping is common on old engines; heavy oil loss means O-ring replacement needed.

✓

Engine Cradle Rust , Inspect the engine cradle crossmember from underneath for rust. Structural rot here requires welding repair.

✓

Turbo Shaft Play , On Spyder/Corsa turbo cars, check turbocharger shaft play with engine off. Excessive play indicates center section bearing wear.

✓

Carburetor Sync , Start the engine and listen for even running. A badly-synchronized 4-carb setup runs rough; a properly tuned one is smooth.

✓

Floor Pan Condition , Probe floor pans from underneath. Rust at seat mount areas and forward of the rear axle is common on unibody Corvairs.

✓

Rocker Panels , Check rockers with a magnet. Filler is non-magnetic. Check for perforation at the rocker-to-quarter junction.

✓

Trim Level Verification , Locate the firewall data plate and verify the original trim level: 500, 700, Monza, or Corsa. Corsa cars command a premium.

✓

Rear Suspension Condition , On 1960–1964 cars, inspect the camber compensator bar. On 1965–1969 cars, check the fully-independent U-joints for wear and play.

✓

Convertible Top Operation , Operate the top through a full raise-and-lower cycle. Check the header seal and side seals for leaks and smooth operation.

Common Issues

Missing or damaged cooling tin is the most serious reliability issue, overheating causes cracked cylinders, a very expensive repair ($3,000–$6,000). Push-rod tube O-ring failure causes oil seeping; budget $200–$400 for O-ring replacement. Engine cradle rust is structural and requires welding. Carburetor synchronization on 4-carb cars is a skill, a badly-tuned setup runs rough and deters buyers. Early swing-axle cars (1960–1964) reward understanding of the suspension geometry. Turbocharger center section bearing failure is repairable but requires a Corvair specialist.

What to Look For

Inspect the cooling tin around the rear engine before anything else, every piece of shrouding must be present and correctly fitted. Missing tin causes cylinder overheating and cracking. Check the 12 push-rod tubes for oil seepage. Inspect the engine cradle crossmember underneath for rust, structural. On turbo cars, check turbocharger shaft play with engine off. Inspect body for unibody rust points: rocker panels, floor pans, lower quarters, and rear valance. On convertibles, inspect the top mechanism and header weatherstripping. Verify trim level via the firewall data plate to confirm Corsa or Monza designation.

Price Guide

First-gen 1960–1964 base coupe driver: $7,000–$14,000. First-gen convertible: $15,000–$28,000. Monza Spyder turbo: $14,000–$22,000. Second-gen 1965–1969 base coupe: $10,000–$18,000. Corsa 4-carb: $16,000–$26,000. Corsa turbocharged: $20,000–$35,000. Second-gen convertible: add $5,000–$10,000. Rampside pickup: $18,000–$32,000. Greenbrier van: $12,000–$25,000. Corvairs remain a significant value relative to contemporary Mustangs and Camaros.

Did You Know?

Ralph Nader published "Unsafe at Any Speed" in 1965 primarily targeting the Corvair, the same year Chevrolet introduced the fully revised second-gen with independent rear suspension. A 1972 NHTSA study found the 1960–1963 Corvair's handling "not significantly worse" than contemporary vehicles. The Corvair was the only American car built simultaneously as a sedan, coupe, convertible, station wagon, van, and pickup truck on the same platform.